Major Operating Controls And Their Functions - Panasonic AW-PB504N Operating Instructions Manual

MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS

1 ZOOM/FOCUS connector
This is the standard input connector for the lenses
equipped with a remote control function for zoom
focus.
When using a Panasonic pan/tilt head (such as the
AW-PH300A, AW-PH350), use the LENS I/F
connector on the pan/tilt head instead of this
connector.
2 SDI output connector [SDI OUT1, 2]
Serial digital component signal can be output.
3 Setting switches
1
2
3
4
1: EDH <ENABLE/DISABLE>
An EDH flag is added to SDI output at the
ENABLE setting.
2: Model selection <CAMERA/AW-EX500>
Select the type of device to be used.
3: DATA CLIP <NORMAL/CLIP>
At the NORMAL setting, signal input is output at
the same level at which it was input.
At the CLIP setting, signal input at smaller then 0%
is output at 0%, and signal input at more than
100% is clipped at 100%.
4: NTSC/PAL switching <NTSC/PAL>
Leave this switch at the factory setting.
-6-
SW NO OFF
O
1 EDH ENABLE DISABLE
N
2 SETTING CAMERA EX500
3 DATA CLIP NORMAL
4 NTSC/PAL NTSC
(Factory setting: ENABLE)
(Factory setting: CAMERA)
(Factory setting: NORMAL)
(Factory setting: NTSC)
ON
CLIP
PAL