Table of Contents
Advertisement
• The equipment can be removed using the following procedure.
Driver (R side)
Set
Driver (L side)
Note :
Follow the disassembly procedure in the numerical order given.
2-1. DRIVER (R SIDE)
Driver (R side)
4 Remove the two solderings
2-2. RX BASE BOARD
4 Knob, volume
2 Remove the ten solderings
1 Two screws (+P2 × 6)
SECTION 2
DISASSEMBLY
Lid (R), holder
RX BASE board
RX CHR board
Lid (L), holder
3 Plate (R) assy, front
2 Four screws
(+P2 × 6)
Precaution for installation
Solder the each lead wires directly to the position as
shown while being cautions of colors
3 Button, sound selection
RX BASE board
Hanger (R)
Hanger (L)
Holder (L)
Precaution for installation
Driver (R side)
1 Pad, ear
RX BASE board
Driver (red)
Head band (front) (natural)
Head band (front) (black)
— 3 —
RX SW board, Holder (R)
Solder the each lead wires
directly to the position as
shown while being
cautions of colors
Natural
Red
From RX BASE board
Head band (rear) (natural)
Head band (rear) (red)
from RX SW board (–) (natural)
from RX SW board (+) (black)
Head band (front) (natural)
Head band (front) (green)
Driver (natural)
Advertisement
Table of Contents
