Safety Features - Harman PP38+ Installation & Operating Manual

Harman stove company stove user manual
Table of Contents

Advertisement

Maintenance - cleaning the Feeder body
Pellet fines may accumulate in the feeder body over
a period of time; therefore, a yearly inspection and
cleaning of this area must be performed.
To clean out fines:
1. Remove the rear cover panels.
2. Remove wing nut and feeder cover on the
side of the feeder.
3. Use a vacuum cleaner to remove all fines.
4. Reinstall feed cover, wing nut, and rear
cover panels.
Hopper Lid
Position Switch
The low draft sensor which is a vacuum differential switch, monitors the negative pressure (draft) in the firebox
through a port on the rear of the feeder. Poor draft will result in an interruption of power to the feeder motor. Poor
draft can be caused by blockage in the exhaust, excessive build-up on the combustion blower fan blades, a failed
combustion blower, or a door or other opening to the firebox not sealed properly. The hopper lid position switch,
located in the right rear corner of the hopper opening, will also interrupt power to the feeder if the hopper lid is not
closed properly. The circuit board is monitoring the position of these switches. During a feed cycle, if either of these
switches were to open, the feed motor light on the control will stay illuminated with the power being interrupted
by the switch. If the switch opens when the cycle is at rest, the power light for the feed motor will not illuminate.
Be sure all doors, including the hopper lid, are securely closed when operating the appliance.
24
PP38+ Pellet Stove
Pellet Fines may
build up in this
area

safety Features

5/16" Hex Head
Screws (2 on
each side)
Fig. 39
5/16" Hex Head
Screws (2 on
each side)
Low
Draft
Sensor
Air
Intake
Flapper

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents