Table of Contents
Advertisement
Operation & Set Up
1. Remove the unit from its packaging
2. To begin using the COOLER/HUMIDIFIER function, rotate the Cord winding
frame clips 90° and remove the water tank located at the back of the unit and fill
to the MAX fill line. Replace the water tank and secure the clips.
3. For extra cooling power, place an ice pack (supplied) into the water tank.
4. Open the horizontal louvres.
5. Plug into a power supply and press the ON/OFF button to start the appliance.
6. The unit will operate initially on a continual basis. If a set period of operation is
required, please follow the TIMER instructions on page 8.
7. Select the desired fan SPEED by pressing the SPEED button. Refer to page 8 for
different settings.
8. Select the operation MODE as required, by pressing the MODE button. Refer to
page 9 for different settings.
9. Press the LEFT / RIGHT or UP / DOWN swing function as required.
10. To switch the unit off at any time, press the ON/OFF button.
Precautions
• Do not overfill the water tank (check the MAX fill line).
• Only fill the water tank half full, when using the ice packs.
• Use only cold, clean filtered water.
• The unit is equipped with a number of safety devices, including a water level
protection, uninterrupted power memory function & auto power off function.
• Do not allow the same water to sit in the machine for a prolonged period.
• It is recommended that any water left in the machine for 3 days or more be re-
moved and replaced with clean water.
• The control panel must not come in contact with water or any other liquids.
Using the Remote Control
1. Unscrew and open the battery cover of the remote control, and insert a 3V
CR2032 battery.
2. Please point to the receiver when using the remote control.
3. If the battery voltage is low, please open the battery cover and replace with a
new battery (CR2032). Then replace the battery cover.
11
Advertisement
Table of Contents
