Selecting Turning Tools - Grizzly G0462 Owner's Manual

Selecting Turning
Tools
Lathe tools come in a variety of shapes and sizes
and usually fall into five major categories.
refer to Accessories on page 28 for examples of
recommended wood chisels from grizzly.
• Gouges—mainly used for rough cutting,
detail cutting, and cove profiles. the rough
gouge is a hollow, double-ground tool with
a round nose, and the detail gouge is a hol-
low, double-ground tool with either a round or
pointed nose. figure 27 shows an example
of a gouge.
figure 27. gouge.
• Skew chisel—A very versatile tool that can
be used for planing, squaring, V-cutting,
beading, and parting off. the skew chisel
is flat, double-ground with one side higher
than the other (usually at an angle of 20-40˚).
figure 28 shows an example of a skew
chisel.
figure 28. skew chisel.
g0462 Wood Lathe (mfg. since 3/10)
Scrapers—mainly used where access for
•
other tools is limited, such as hollowing oper-
ations. this is a flat, double-ground tool that
comes in a variety of profiles (round nose,
spear point, square nose, etc.) to match
many different contours. figure 29 shows an
example of a round nose scraper.
figure 29. round nose scraper.
parting Tools—used for sizing and cut-
•
ting off work. this is a flat tool with a sharp
pointed nose that may be single- or double-
ground. figure 30 shows an example of a
parting tool.
figure 30. parting tool.
Specialty Tools—these are the unique,
•
special function tools to aid in hollowing, bowl
making, cutting profiles, etc. the swan neck
hollowing tool shown on page 29 is a good
example of a specialty tool.
-23-