Table of Contents
Advertisement
6.
With help from another person to steady the
canister assembly, turn it upside down and
remove the two hex bolts, hex nuts, and flat
washers from the cross support (see figure
75), then remove the canister base from the
assembly.
figure 75. Cross support fasteners.
7.
Carefully lift the filter from the canister assem-
bly, as shown in figure 76.
figure 76. removing the filter from the canister
assembly.
-46-
remove these
8.
Before re-inserting the filter into the assem-
bly, make sure that the filter brush base is
aligned with two of the fastener holes around
the base of the assembly (see figure 77).
this will allow the canister base to align with
the fastener holes around the brush base.
Brush Base
figure 77. Filter brush base aligned with
assembly fastener holes.
9.
re-insert the filter into the canister assem-
bly.
note: Make sure the bristles of the brush are
pointed straight into the pleats to ensure effi-
cient cleaning of the filter when needed.
10. Attach the canister base in the reverse order
from which you removed it in step 6.
11. Attach the canister assembly to the dust col-
lector, then secure a new collection bag to it
with the bag clamp.
Model g0442/g0601 (Mfg since 3/12)
Advertisement
Table of Contents
