32. slide the reducer over the inlet port on the
barrel (figure 36), line up the mounting
holes, and secure it in place with the (3) M4 x
12 sheet metal screws.
reducer
figure 36. reducer installed.
33. secure the vacuum hose inside the upper
and lower stand legs with the (2) u-shaped
clips (see figure 37).
figure 37. securing the vacuum hose to the
stand legs.
-28-
34. Mount the switch on the stand, as shown in
figure 38, with (3)
⁄
3
x 3
note: The hand-held remote control uses IR
(infrared) to communicate with the control
box receiver port, and must have direct line-
of-sight to the control box face. Locate the
control box with this in mind.
⁄
"-16 x
3
8
" flat washers, and (3)
8
figure 38. switch mounted to stand.
Model g0442/g0601 (Mfg since 3/12)
⁄
" hex bolts, (6)
3
4
⁄
"-16 hex nuts.
3
8