Table of Contents
Advertisement
1-3
Installing and Removing the CPU
Read the following guidelines before you begin to install the CPU:
• Make sure that the motherboard supports the CPU.
• Always turn off the computer and unplug the power cord from the power outlet before installing
the CPU to prevent hardware damage.
• Unplug all cables from the power outlets.
• Disconnect all telecommunication cables from their ports.
• Place the system unit on a flat and stable surface.
• Open the system according to the instructions.
WARNING!
Failure to properly turn off the server before you start installing components may cause serious
damage. Do not attempt the procedures described in the following sections unless you are a
qualified service technician.
Follow these instructions to Install the CPU:
1.
Gently press the CPU socket lever handle down to unclip it.
2.
Completely lift the CPU socket lever.
3. Use the finger tab to lift open the metal load plate.
4.
Align the CPU pin one (triangle marking) with the pin one corner of the CPU socket (or you may align the
CPU notches with the socket alignment keys). Gently insert the CPU into position.
5.
Once the CPU is properly inserted, carefully replace the load plate.
6.
The plastic protective cover will pop off. Then, remove the CPU cover.
Note:
Save and replace the CPU cover if the processor is removed from its socket.
6
Secure the CPU socket lever.
Finger Tab
3
1
5
Pin One
4
Hardware Installation
2
6
- 11 -
Advertisement
Table of Contents
