Safety Instructions - Global Machinery Company POL1450 Instruction Manual

Safety instructions

The tool must be used only for the prescribed purpose.
Any uses other than those mentioned in this manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
To use this tool properly, you must observe the safety
regulations, the assembly instructions and the operating
instructions to be found in this Manual. All persons who
use and service the machine have to be acquainted with
this Manual and must be informed about its potential
hazards. Children and infirm people must not use this
tool. Children should be supervised at all times if they are
in the area in which the tool is being used. It is also
imperative that you observe the accident prevention
regulations in force in your area. The same applies for
general rules of occupational health and safety.
The manufacturer shall not be liable for any changes
made to the tool nor for any damage resulting from such
changes.
Warning. Before connecting a tool to a power source
(mains power point receptacle, outlet, etc.), be sure that
the voltage supply is the same as that specified on the
nameplate on the tool. A power source with a voltage
greater than that specified for the tool can result in
serious injury to the user, as well as damage to the tool.
If in doubt, do not plug in the tool. Using a power source
with a voltage less than the nameplate rating is harmful
to the motor.
Even when the tool is used as prescribed it is not possible
to eliminate all residual risk factors. The following hazards
may arise in connection with the tool's construction and
design:
• Contact with the disc.
• Kickback of work piece and parts of work piece.
• Disc fracture.
• Catapulting of disc pieces.
• Damage to hearing if effective earmuffs are not worn.
• Do not use discs that are deformed or cracked.
• Always remove the plug from the mains socket before
making any adjustments or maintenance, including
changing the disc.
Warning. When using power tools, basic safety
precautions should always be taken to reduce the risk of
fire, electric shock and personal injury. Also, please read
and heed the advice given in the additional important
safety instructions.
1. Keep the work area clean and tidy.
areas and benches invite accidents and injury.
2. Consider the environment in which you are working.
Do not use power tools in damp or wet locations. Keep
the work area well lit. Do not expose power tools to
rain and high humidity. Do not use power tools in the
presence of flammable liquids or gases.
3. Keep visitors away from the work area.
and onlookers, especially children and infirm persons
should be kept well away from where you are working.
Do not let others in the vicinity make contact with the
tool or extension cord.
4. Store tools safely.
stored in a dry, high place or locked up out of reach.
5. Do not force the tool.
and safer working at the rate for which it was
designed.
6. Use the correct tool for the job.
tools or attachments to do the job best handled by a
heavier duty tool. Never use a tool for a purpose other
than that for which it was intended.
7. Dress correctly. Do not wear loose clothing or
jewellery. They can be caught in moving parts. Rubber
gloves and non-slip footwear are recommended when
working outdoors. If you have long hair, wear a
protective hair covering.
8. Use safety accessories.
should always be worn. A face or dust mask is also
required.
4
Cluttered work
All visitors
When not in use, tools should be
The tool will do the job better
Do not force small
Safety glasses and earmuffs