Global Machinery Company POL1450 Instruction Manual page 10

9. To tighten, press and hold the spindle lock button (2)
and using the pin wrench tighten the outer flange.
10. Turn the new disc by hand, ensuring that it is tight in
the flanges and that it rotates fully and does not
wobble unduly.
11. Run the angle grinder at no load for at least one
minute to ensure the new disc is in good condition.
Make sure you are wearing all the safety gear and
that you face the grinder away from you.
Switching on and off
Before starting the grinder, first ensure the disc, guarding
and the tool is in good condition. Plug the cordset into
the mains socket and set up for the task to be performed.
Warning. Ensure you are wearing safety glasses.
1. Hold the tool firmly in anticipation of the start up
torque.
2. Press and hold the lock-off button (8) and squeeze the
on/off trigger switch (7).
Note. Once the tool has started there is no need to
maintain pressure on the lock-off button.
3. Allow the grinder to start and attain full speed before
bringing the disc to the work piece.
4. To prevent a new grinding disc from digging into the
work piece, first draw the grinder across the work piece
towards the operator. Once the leading edge of the disc
is slightly worn down, grinding can be conducted in
either direction.
5. Once the grinding or cutting is finished, remove the
disc from the work piece. To turn the tool off, release
the on/off trigger switch. The lock-off button (8) will
re-engage.
6. The tool will stop. (Please note that the disc continues
to spin for a few seconds even though the switch is
turned off). Keep hands well away from the moving
disc. Do not place the tool down until the grinder has
come to a complete stop.
Holding and guiding the tool
1. Always clamp the work piece.
2. Do not overload the tool so that the disc slows down.
Let the tool do the work rather than applying pressure.
The weight of the tool alone provides sufficient
pressure.
3. Cutting discs become very hot when in use. Take care
not to touch them until they have cooled down.
4. Hold the tool securely and make sure that you have full
control at all times.
5. During a cutting operation, maintain an angle of 30 to
40 degrees between the tool and the work piece.
6. During grinding, maintain an angle of 15 to 30 degrees
between the tool and the work piece.
10