Table of Contents
Advertisement
3.
Attach the supplied right angle mounting brackets to the bottom of the heater (front hole of bracket) using the
rear most of the pre-installed case screws as shown below.
Use the rear most of the pre-installed case screws
4.
Hang the heater using the slots located on the back of the appliance and secure the right angle mounting
brackets to the wall with appropriate fittings as shown.
600mm
L
5.
Remove the cable tie from the flexible cord, then insert the power plug of the heater directly into a power
socket outlet.
DO NOT bundle or coil the flexible cord to reduce the length as overheating and subsequent fire
hazard could result.
IMPORTANT
6.
The heater is now ready to be used as a free standing appliance. Refer to the operation section at the front
of this manual for full instructions on how to use the heater.
Rinnai
Slots for mounting the heater
to the wall mounting hooks
Screw
to wall
17
INSTALLATION
Install right angle mounting
bracket using the front hole
Electric Panel Heater OIM
Advertisement
Table of Contents
