Advertisement
9. Loosely install the baffle flanges to the housing with
(3) 5/16–18 x 5/8" bolts, washers and 5/16-18 locknuts
(Fig. 5). The bolt heads are to be positioned inside the
mower deck and the washers are to positioned next to
the nuts.
10. Loosely install the rest of the baffle to the housing
with (6) 5/16–18 x 5/8" bolts and 5/16-18 locknuts.
The bolt heads are to be positioned inside the mower
deck.
11. Tighten all mounting hardware securely.
Install Recycler
1. Remove standard blades and anti-scalp cups from
spindles.
Note: Save blades and anti-scalp cups for use when side
discharging.
®
2. Install Recycler
blades in kit. Secure washer and
bolt previously removed (Fig. 6).
3. Rotate blades to assure there is at least 1/8" clearance
between blades and baffle.
2
4
5
Figure 6
1. Sail Area of Blade
® blade
Recycler
2.
3. Anti-scalp cup
4. Install mower onto traction unit; refer to Installing the
Mower, in Mower Operator's Manual.
Removing the Recycler
1. Thoroughly clean the mower.
2. Remove lock nuts from top and center of right side
baffle (Fig. 7). Lower baffle and slide out of discharge
opening to remove.
Note: Only the right side baffle need be removed for side
discharge mowing.
®
Blades
1
3
m–1082
4. Washer
5. Blade Bolt
Baffle
®
3. Install previously removed 5/16–18 x 5/8" (16 mm)
bolts and 5/16-18 locknuts in open holes of mower for
safety (Fig. 7).
2
2
3
Figure 7
1. Baffle left side
2. Bolt 5/16-18 x 5/8"
(16 mm)
POTENTIAL HAZARD
• Open holes in the mower expose you and
others to thrown debris.
WHAT CAN HAPPEN
• Debris thrown out of holes in the mower
can cause injury.
HOW TO AVOID THE HAZARD
• Never operate mower without hardware
mounted in all holes in mower.
• Install hardware in mounting holes when
recycle baffle is removed.
3
3
1
2
m-2414
3. Locknut 5/16-18
Advertisement
