Cisco Linksys RE1000 Getting Started page 5

RE1000 Range Extener
7. Move the extener to its primary location, then click Next. Your router
tests the wireless connection to your relocate extener an prompts
you if it nees further ajustment.
TIP
You can also connect the range extener by using Wi-Fi Protecte
Setup. For more information, see "Using Wi-Fi Protected Setup" on
page 7.
How to change the power plug configuration
You can connect the extener's built-in power plug irectly to a wall power
outlet. For a esktop or table-top setup, you can also remove the built-in plug
an use an AC cable instea.
To attach the AC power plug:
1. Press the plug release latch, then slie the AC plug off the extener.
2. Slie the clip cover into the slot that hel the AC plug, then connect the
AC cable to the power connector.
Getting Starte
Power connector
(European version of extener shown)
5