Install In The Cx-9 - Mazda CX-9 Instructions Manual

6. Install in the CX-9

There are some good descriptions, coming from Mazda to directly on how to remove the necessary
panels as well as locate the cable connections. I have included a copy of the information in Appendix-C
that is coming from these instructions. I hope it will not get me in copyright trouble for including instead
of referencing, but the information is coming from Internet, I use source reference and I am sure Mazda
wants happy drivers. Thank you Mazda!
Steps

Disconnect the battery (as precaution) - See Appendix-C
a. Disconnection with clear radio-channels and seat-memory.

Remove the panels - See Appendix-C

Appendix-C shows the Body Control Module (BCM). It is located at the front, behind the kick-
panel at the driver side:
a. The white 30-pin connector at the top
b. The white 6-pin connector underneath

Locate the right wires with the right colors and connect the wires from the circuit using the
wire-taps as follows:
o Grey wire: connect to Violet/White (v/w) wire on 30 pin connector; PIN 3R
o White wire: connect to Green (G) wire on 30 pin connector; PIN 1A
o Red wire: connect to Black/Yellow (B/Y) wire on 6 pin connector; Pin 4A
o Black wire: connect to ground/chassis connection on the car

After connection the wires, Connect the Battery - See Appendix -C
Automatic door-lock/unlock CX-9 /2007 Version 1.0 Page 10