Follow the procedure below to integrate the control unit and main unit.
<Note>:
Work on a flat and stable surface. It is recommended to put the units on a soft
cloth (or blanket) to protect the units.
<Necessary items>
• Phillips-head screwdriver (which matches the fixing screws for rack mounting)
• The supplied CAT-5 cable
(1)
Remove the rack mount adaptors attached to the side panels of each unit.
The removed rack mount adaptors and fixing screws are used in step (3) below, so be
careful not to loose them.
Rack mount adaptor
Rack mount adaptor
(2)
Connect the [ETHER] connector of the control unit and the [CONTROLLER] connector
of the main unit using the supplied CAT-5 cable.
The cable should run through the cable guides fixed near the connectors of the both
units (see below).
<Note>:
cable while the LM16 is powered on.
When you connect or disconnect a CAT-5 cable,
make sure that the LM16 is powered off.
CONTROLLER
<Note>:
Integrating the control unit and main unit
Do not connect or disconnect a CAT-5
Main unit
Insert the connector of the cable firmly in the correct direction.
Model LM16 [Before using the unit]
Main unit
Control unit
Cable guide
Control unit
13
Rack mount adaptor
Rack mount adaptor