Alarm Function; Auto Power Off Function - SATO SK-150GT Instruction Manual

Alarm Function

The alarm is triggered with sound of buzzer when the WBGT reading exceeds the set value.
Note: The alarm function is only available for WBGT. It cannot be set for temperature, globe
temperature or relative humidity.
Also, this instrument is automatically turned off if it is not in operation for more than 20
minutes. In case of using it for longer than 20 minutes, release the Auto-Power Off
function.
* Refer to the "Auto Power-Off Function" for the instructions.
⚫ How to Set Alarm Function
① Press the MODE/Up key to display the WBGT mode.
② Press the SET key for more than 2 seconds to display the alarm setting mode.
③ Press the MODE/Up key to increase the value of the blinking digit.
Press the IN_OUT key to change the digit.
Note: Set the alarm within the range of 20.0 to 49.9°C.
It is not possible to disable the alarm function. If you do not want the alarm to be
alerted, set the alarm to its maximum limit, 49.9°C.
④ Press the SET key for longer than 2 seconds to confirm the setting.
Caution: If you turn the power off before confirming the alarm setting, the instrument
recalls the last fixed value for the alarm.
Auto Power-Off Function
If the instrument is not in use for more than 20 minutes, the power is automatically turned off
for power saving purpose.
⚫ How to Release Auto Power-Off Function
① Make sure the instrument is turned off.
② Press the POWER key and the HOLD key simultaneously.
③ Release the buttons once the power turns on and the "n" mark is shown on the LCD. The
"n" mark disappears and the measuring mode starts, meaning the Auto Power-Off
function is successfully released.
Caution
The release setting is no longer effective once the power is turned off. Do the same
procedure whenever the Auto Power-Off function is not needed,
7