Dell EMC VEP4600 Installation Manual page 22

2. BMC image[Primary version:2.20, backup version:1.22]
3. BIOS image[Booted version: 3.41.0.9-19]
4. CPLD image[CPLD version: 0x10]
9. Reset BMC after CPLD update completion and system bootup
q. Exit
Enter your choice:q
~/Downloads/temp
root@ubs18-04:~/Downloads#
5. After firmware upgrade completes, enter q to exit.
6. Once all firmware updates are complete, a system power cycle is required either with remote power cycler or manually
unplugging and plugging back the power cord.
NOTE: The power down state should be a minimum of fifteen seconds for the complete power drain.
NOTE: UFW has been tested for use with Ubuntu 18.04 and CentOS/RHEL 7.x.
NOTE: If an IPMI session error is seen while connecting to the BMC, run following command to reset the BMC prior to
re-run of UFW. root@ubs18-04:~/# ipmitool -I lanplus -H xxx.xx.xx.xxx -U admin -P admin mc reset cold
NOTE: UFW has a limitation that rNDC and x722 firmware upgrade cannot be done through the BMC network.
Firmware upgrade options available for this hardware via DIAG OS and firmware workaround sections.
22 Upgrade firmware through BMC