Jacobsen LF 3810 Dealer's Manual page 27

Product No.
Tractor —————————————————
Check:
Wheel lug torque:
Front 80 - 100 ft. lb.
Rear 40 - 45 ft. lb.
Tire pressure should be:
Front 10-12 psi (69-83 kPa)
Rear 8-10 psi (55-69 kPa)
Hydro linkage neutral centering adjustment (unit must not
creep in neutral)
Traction pedal stop adjustment
Parking brake adjustment
Engine —————————————————
Check:
Engine oil level
Engine coolant level
Air cleaner element and connections
Belt adjustments
Electrical System ————————————
Check:
Interlock switch function
Neutral start switch
Parking brake switch
Mower PTO switch
Mower limit switch
Seat switch / Time delay relay
Operation of all function control switches
4WD cut-out switch (4WD only)
Function of crosscut feature
Dash panel gauges and warning lights
For pinched or rubbing wires
Should you encounter any areas that required repair during set-up, please explain below and fax (414/635-1067) a copy of the
checklist and problem description to use.
Problem Description ______________________________________________________________________________________
________________________________________________________________________________________________________
________________________________________________________________________________________________________
________________________________________________________________________________________________________
Dealer ____________________________________________
Customer ____________________________________________ Date _____________________________________________
Pre-Delivery Checklist
Product No. 67827/67828 – LF-3810 Fairway Mower
_____________________
Serial No.
______________________
Hydraulic System————————————
Check:
Hydraulic oil level
For pinched or rubbing hoses
For twisted or crimped hoses
For oil leaks
Hydro tow valve is in 'Drive' position
Backlap valves are fully closed
Determine GreenSentry™ is operational
Cutting Units ——————————————
Check:
Bedknife screws for tightness
Reel for end play; there should be no free end play
Roller bearing adjustment
Reel drive belts adjustment
All hardware properly tightened
Adjust reel weight springs to give equal weight to all cutting
units. Caution: Check maximum safe exposed thread
length in the Parts & Maintenance Manual before making
this adjustment.
Reel to bedknife clearance, .001" to .003" (.025 - .08 mm).
Adjust cutting height to customers' specs. (.025 - .08 mm)
Miscellaneous —————————————
Check for loose or missing hardware
All lubrication points
Examine paint finish; touch up where necessary
Check decals. In place and legible
Make sure Manuals are in the pouch
______________________________________________
______________________________________________
Inspected by _______________________________________