Table of Contents
Advertisement
Figure 11
6.10 Clamping Pressure
The XACTA Fence has been adjusted by the
manufacturer to lock securely when lock handle is
pushed down. If adjustment is needed:
1.
Unlock fence.
49. Remove fence from guide tube and turn it
over.
50. Adjust each of two setscrews (A, Figure 11)
exactly the same number of rotations until the
fence is held securely when lock handle is
pushed down.
6.11 Checking 90 to Table
1.
Place fence on saw table and lock it.
51. Place a square (A, Figure 12) on table next to
fence. The fence should be 90 to the table.
52. If adjustment is necessary, unlock fence and
turn one of two nylon adjustment screws (B,
Figure 12) until fence is 90 to table.
53. Lock fence and check the adjustment again.
Figure 12
6.12 Cursor Adjustment
1.
Disconnect saw from power source.
54. Raise blade above table top.
55. Unlock fence and slide it to approximately four
inches from blade.
56. Lock the fence.
57. Measure distance between saw blade and
inside of fence.
58. Adjust cursor (C, Figure 12) to read the
distance just measured, and tighten cursor
assembly to fence.
59. Make a test cut and confirm the adjustment is
correct.
Note: If the cursor does not have enough travel to
give the correct measurement, loosen guide rail
and adjust as needed. If you still do not get the
correct measurement, loosen front rail and adjust
as needed. If you have to adjust front rail you will
need to go through the front rail assembly
instructions again.
Cursor accuracy should be checked whenever a
different blade is installed.
After installing the XACTA Fence, press the black
plastic end covers into the openings of the guide
rail. There is also an end cover for the fence that
may already be installed.
10
Advertisement
Table of Contents
