Das101Cm Series, And Dav-Das Interconnection - Extron electronics DAS101CM Series User Manual

connect the power supply to a DAS101CM module's 12 VDC
In port and loop the power through to the DAV101CM via the
DAS101CM's 12 VDC Out port (see
N
C
b
15-pin HD computer-video output (DAV101CM-1, -2, -5) —
Attach this connector to the display's 15-pin HD input
connector.
c
BNC computer-video output (DAV101CM-3, -4, -6) — Attach
these five male BNC connectors to the display's BNC input
connectors.

DAS101CM Series, and DAV-DAS interconnection

DAS101CM-1, -2, -5
Top View
1
DAS101CM-1, -2, -5 Rear View
a
12 VDC, 0.1 A In (power input) — Connect a 12VDC, 1 A power
supply to these two poles of the DAS's 4-pole direct insertion
captive screw connector for power input.
C
b
12 VDC, 0.1 A Out (power loop-through for DAV101CM
modules) — This port allows power to be looped through to a
DAV101CM. See the wiring diagram on the next page.
DAV101CM, DAS101CM • Installation and Operation
Do not tin the stripped power supply leads before
installing the captive screw connector.
Correct polarity is important! The power wires must
be attached to the correct terminals or the module can
be damaged.
12VDC
0.1 A
2 3
Correct polarity is important! The power wires must
be attached to the correct terminals or the module can
be damaged.
page 2-6).
DAS101CM-3, -4, -6
Top
View
12VDC
0.1 A
1 2
DAS101CM-3, -4, -6 Rear View
3
2-5