5. Remove (11) screws securing the
radio"dummy" bracket: (Figure E)
a. (2) T-27 Torx screws shared with
the gauge cluster and a third T-27
Torx screw to remove the gauge
cluster in step 7.
b. (4) 5/32" Allen screws facing outward.
c. (4) T-25 Torx screws secured to the
radio "dummy".
d. (1) T-25 Torx screw shared with the
storage pocket.
6. Remove the radio bracket. (Figure E)
Note: This bracket will be reused with
the kit assembly.
7. Remove the gauge cluster. (Figure E)
8. Remove (4) 3/16" Allen screws from the
sides of radio. (Figure F)
Note: These screws will be reused with
the kit assembly.
9. Slide the radio out toward the rear of
the bike, disconnect the wiring, and
then remove the radio. (Figure F)
FAIRING DISASSEMBLY
(Figure E)
(CONT)
(Figure F)
3
REV. 12/1/21 INSTBC-HDR-K4