Husqvarna LC 356VP Operator's Manual page 9

To start the product
1. Make sure that the ignition cable is connected to the
spark plug.
2. Stay behind the product.
3. Hold the engine brake handle against the handlebar.
4. Hold the starter rope handle with your right hand.
5. Slowly pull out the starter rope until you feel some
resistance.
6. Pull with force to start the engine.
WARNING:
rope around your hand.
To use the drive on the wheels
• Start the drive on the wheels with the speed control
lever on the left side of the handle. Move the speed
control lever forward to increase the speed and
rearward to decrease the speed.
• Before you pull the product rearward, disengage the
drive and push the product forward approximately 10
cm.
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
To stop the product
• To stop the drive only, release the drive bail.
• To stop the engine, release the engine brake handle.
To use the product with the grass
catcher
WARNING:
without a grass catcher installed or without
the rear cover closed. Objects can eject and
cause injury to the operator.
1583 - 005 - 24.11.2021
Do not twist the starter
Do not operate the product
1. Lift the rear cover and remove the mulch plug if it is
installed.
2. Assemble the grass catcher, refer to
the grass catcher on page 7 .
3. Put the grass catcher on the bracket.
4. Release the rear cover and put it on top of the grass
bag frame.
To change the product to mulch mode
Make sure the engine is off before you change the
product to mulch mode.
1. Lift the rear cover and remove the grass catcher, if it
is installed.
2. Put the mulch plug into the discharge channel.
To assemble
9