Attaching The Belt Clip; Programming The Weatheradio - Radio Shack NWR-SAME Weatheradio Owner's Manual

All manuals and user guides at all-guides.com
A
TTACHING THE
Insert the clip into the hole at the back
of the weatheradio until it clicks. To
remove the belt clip, press the button
on the tip of the clip and pull it out.
A
TTACHING THE
S
TRAP
Slide the wrist strap's small loop under
the bar at the back of the weatheradio.
Then pull the strap's large loop through
the small loop and fasten it.
PROGRAMMING THE
WEATHERADIO
Ô Ô
Your Weatheradio
NOTE
with seven NOAA broadcast
• The weatheradio
frequencies (channels 1-7). Depending
does not receive alert
on your location, you might need to
signals during
programming. select a different channel.
• If you press MENU or
Your Weatheradio
do not press a key for
any weather alert broadcast within
45 seconds while
about a 50 mile radius. The first time
programming, the
you use your Weatheradio
weatheradio saves
all valid entries you for the strongest channel and receives
made and exits
all SAME alert signals broadcast within
programming mode. a 50 mile radius of its location. Ô
6
B C
ELT LIP
W
RIST
( )
NOT SUPPLIED


is pre-programmed

is preset to receive

, it scans