Advertisement
Operations
Carpet Cleaning
1. Remove Dirty Water Tank. Pull tank handle to
upright position and lift up to remove.
2. Lift Clean Water Tank from the base of
machine.
a. Unscrew cap on top of the Clean
Water Tank. Fill tank to FILL line with
clean, warm tap water (60°C/140°F
MAX). Do not boil or microwave water.
b. Measure BISSELL® formula using cap
on tank. Fill cap to line twice for each full
tank of water. Always use genuine BISSELL
formulas to maximize cleaning and for the
safety of your machine
c. Screw cap back onto Clean Water Tank and
place tank onto base of the machine.
3. Replace Dirty Water Tank securely on top of
the Clean Water Tank and push handle back to
lock into place.
4. Plug into a proper outlet and turn the
Power Switch to the ON ( I ) position.
5. Recline handle by pushing down on the
green lever on the back of the machine while
pulling back on handle.
6. Cleaning strokes. While pressing the trigger,
make one slow forward wet pass and another
back. Let the formula and DirtLifter PowerBrush
do the work for you.
NOTE: Your machine is equipped with a circuit
breaker that will automatically shut off the brush
if a large or loose object is caught in the Brush
Roll. If that happens, be sure to unplug your
machine, remove the foreign object and then
plug machine in to reset the circuit breaker.
7. Release the trigger and make one slow
forward and backward pass over the same area
to remove any residual dirty water and aid in
drying. Repeat cleaning passes until solution
being pulled up appears clean.
8. Continue passes without pressing the trigger
until you can't see any water being pulled up.
9. Remove the Dirty Water Tank by pulling the
handle to the upright position and lifting up.
Carry the tank like a bucket to a utility sink or
outside where you will dispose of the dirty water.
10. Unlatch the top of the tank from the bottom
by pushing the handle all the way forward and
lifting the top off. Pour dirty water into the sink.
NOTE: You may notice hair and debris deposits
on the carpet or in the tank that were loosened
by the cleaning action (especially with newer
carpets that have never been cleaned before).
This debris should be picked up and thrown
away.
11. Fill the Clean Water Tank with clean, warm
tap water (60°C/140°F MAX) and follow
instructions 2 - 8 to continue cleaning.
6
BISSELL.com
Do not overwet. Take care not to run over
loose objects or edges of area rugs. Stalling
brush may result in premature belt failure.
1.
60C
2.
2c.
3.
9.
10.
CAUTION
2a.
3.
5.
Advertisement
