Advertisement
Maintenance & Care
Brush Removal and Replacement
1. Turn OFF (0) the machine and unplug from
the outlet.
2. Remove the Dirty and Clean Water Tanks
from the base of the machine.
3. While standing behind the machine, lay the
machine on its side (cable side down).
4. Looking at the bottom of the machine, find
the center of the brush carriage where the red
carriage latch is located. It is between the brush
assembly and wheels.
5. Pinch the carriage latch while pulling the
carriage towards you. The carriage should
swing out to access brush end cover.
6. Remove three screws from endcap.
Pull endcap off to release Brush Roll.
7. With cover removed, the brush comes
out easily by tilting the loose end out of the
carriage.
8. To replace the Brush Roll back into the
machine, place the large open end of the brush
onto the carriage and tilt opposite end back
into place.
9. With the brush sitting relatively straight up
and down by itself, place endcap back on top
and replace three screws. The brush will need to
be held and centered to the cover while
placing it back on.
10. Spin the brush by hand to make sure it
turns freely with some minor resistance from
the motor. Push brush carriage back into place
with a light pull against the lock.
10
BISSELL.com
WARNING
To reduce the risk of electric shock, turn Power Switch
OFF and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
4.
6A.
7.
9.
5.
6B.
8.
10.
Advertisement
