Cutting Curves; Troubleshooting Guide; Saw Will Not Start; Breaker Kicks Out Frequently - Delta 28-276 Instruction Manual

CUTTINg CURVES

Turn the stock carefully so that the blade follows without twisting. For very abrupt curves, consider using a narrower
blade, or a blade with more set. Another solution to this problem is to make relief cuts (Fig. 39).
When you withdraw the workpiece or change the cut, be careful not to accidentally pull the blade off of the wheels.
The preference is to turn the stock and saw out through the waste material.
For assistance with your machine, visit our website at www.deltaportercable.com for a list of service centers or call the
DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).
In spite of how well a band saw is maintained, problems can occur. The following troubleshooting guide will help you solve
the more common problems:
Trouble: Saw will not Start.
Probable Cause
1. Saw not plugged in.
2. Fuse blown or circuit breaker tripped.
3. Cord damaged.
Trouble: BrEaKEr KicKS out frEquEntly.
Probable Cause
1. Extension cord too light or too long.
2. Feeding stock too fast.
3. Blade in poor condition (dull, warped, gummed).
4. Low voltage supply.
Trouble: Band Saw viBratES ExcESSivEly.
Probable Cause
1. Machine not mounted securely to stand.
2. Stand on uneven surface.
3. Worn belt.
4. Pulley not aligned.
5. Motor not fastened securely.

TROUBLESHOOTINg gUIdE

21 - English
Fig. 39
Remedy
1. Plug in saw.
2. Replace fuse or reset circuit breaker.
3. Have cord replaced.
Remedy
1. Replace with adequate size cord.
2. Feed stock more slowly.
3. Clean or replace blade.
4. Contact an electrician.
Remedy
1. Tighten all mounting hardware.
2. Reposition on flat level surface.
3. Replace belt.
4. Adjust pulleys.
5. Tighten all mounting hardware.
(continued on next page)