Kenmore 795.70332.410 Service Manual page 96

https://appliancetechmanuals.com
14-1-11 Ultra ICE
1. The purpose of this function is to intensify the cooling speed of freezer and to increase the amount of ice.
2. Whenever selection switch is pressed, selection/release, the Icon will turn ON or OFF.
3. If there is a power outage and the refrigerator is powered on again, Ultra ICE will be canceled.
4. To activate this function, press the Ultra ICE key and the Icon will turn ON. This function will remain activated for 24 hrs.
The first one hours the compressor, Freezer Fan and Icing Fan(high speed) will be ON. The next 23 hours the Ice room
will be controlled at the lowest temperature. And icing fan run high speed. After 24 hours or if the Ultra ICE key is pressed
again, the Ice room will return to its previous temperature. And icing fan run standard speed.
5. During the first 1 hours :
(1) Compressor, Freezer Fan and Icing Fan(high speed) run continuously.
(2) If a defrost cycle begins during the first 30 minutes of Ultra ICE, the Ultra ICE cycle will complete its cycle after
defrosting has ended.
If the defrost cycle begins when Ultra ICE has run for more than 30 minutes, Ultra ICE will run for 40 minutes after
the defrost is completed.
(3) If Ultra ICE is pressed during defrost, Ultra ICE Icon is on but this function will start seven minutes after defrost is
completed and it shall operate for one hours.
(4) If Ultra Ice is selected within seven minutes after compressor has stopped, the compressor (compressor delays
seven minutes) shall start after the balance of the delay time.
6. For the rest of the 23 hours, the Ice room will be controlled at the lowest temperature. And icing fan run high speed.
14-1-12 How to set the display mode and cancel it
1. With the refrigerator door open, keep pressing the Refrigerator Temp Button and ULTRA ICE Button more than 5
seconds, then it goes to the display mode with Special Beep Sound.
2. Perform the same way again to cancel the display mode.
3. All freezing units do not work at the display mode.
14-1-13 Energy Saver
1. If you want additional power save, you can turn on energy saver (some
heater off for anti-dew).
2. To turn on or off the energy saver function, press Energy Saver Button for
more than 3 seconds.
3. We recommend using energy saver function when you go out for quite a long
time and are out of the rainy season.
- 77 -
Pillar
Heater Off
Pillar
Heater On