Lexmark Optra Compute 500 User Manual page 16

Set up, install, and configure
Notes:
•
This device supports Power over Ethernet, which allows it to be powered using the Ethernet cable
instead of the power supply. To use this mode, make sure that your network can supply Power over
Ethernet 30‑watt mode (PoE+) to the device. Connect the device to the local network using an
Ethernet cable, and then skip step 3. Store the supplied power adapter in a safe place if you want to
use it later.
•
If your network does not support at least PoE+, or if you are not sure, then connect the supplied
power adapter.
3
Connect the device to the local network.
Notes:
•
This device has built-in Wi-Fi. If the only available connection is wired, then insert the Ethernet cable.
•
Skip this step if the device is connected using Power over Ethernet.
Lexmark Confidential until announced
16