Table of Contents
Advertisement
10
Installation Instructions
Connecting inlet water
1.
Run some water from the hot and cold faucets
to flush the water lines and remove particles
that might clog the water valve screens and to
determine which faucet is hot and which is cold
supply.
2.
Look in the end of each water supply inlet hose
and verify that the rubber washers are in place.
RUBBER WASHERS
MUST BE PRESENT
NOTE
HOT and COLD water inlet hoses are color
coded for identification. The HOT inlet hose is
marked with a RED band and the COLD inlet
hose is marked with a BLUE band.
3.
Connect the HOT inlet hose to the HOT water
supply and the COLD inlet hose to the COLD
water supply. Tighten by hand until snug.
4.
Tighten each supply connection another 2/3
turn with pliers.
5.
Turn on the water and check for leaks.
Hide quick links:
Advertisement
Table of Contents
