1000m ethernet optical fiber singlemode media converter – 1310 nm, 20 km (29 pages)
Summary of Contents for Tripp Lite N784-H01-SCMM
Page 1
Fiber Media Converter, RJ45/SC Model: N784-H01-SCSM Este manual está disponible en español en la página de Tripp Lite: tripplite.com Ce manuel est disponible en français sur le site Web de Tripp Lite : tripplite.com WARRANTY REGISTRATION Register your product today and be automatically entered to win an ISOBAR ®...
• Local Loop Back (LLB) tests the copper network connection • Remote Loop Back (RLB) tests the fiber network connection • Auto MDI/MDI-X functionality removes the need for crossover cabling Package Contents • N784-H01-SCMM or N784-H01-STMM or N785-H01-SCSM Media Converter • External Power Supply with NEMA 1-15P Plug (Input: 100-240VAC, 50/60 Hz, 0.5A; Output: 12VDC, 1.5A) •...
A single media converter can be used for a copper-to- fiber installation. • The following installation instructions refer to the N784-H01-SCMM. Connections are the same for all models, with only the specs being different. See the Specifications section in this manual for details on your media converter.
Page 4
Installation Connect the media converter to a second identical media converter using the appropriate type of fiber cable, making sure to connect the TX port on one unit to the RX port on the other. Note: See the Product Features section in this manual to determine which type of fiber cable is supported by your media converter. Connect the RJ45 port on the second media converter to your network device (workstation, hub, switch, etc.) using a Cat5e/6 cable.
LED Status Table Status Description PWR (Green) The unit is powered on PWR (Green) The unit is not powered on ALM (Red) LFS enabled and link fault occurred ALM (Red) LFS disabled or no link fault occurred RJ45 100 (Green) Copper connection up to 100 Mbps 100 (Green) Copper connection speed under...
Page 6
LED Status Table Link Fault Signaling (LFS) The LFS LED will indicate when a cable has been severed or when some other cause of disruption in service has occurred. The LFS function monitors both copper and fiber segments for a total service report. Set DIP Switch 1 (LFS) to ON for normal operational use and to OFF when installing cables or when testing the network connection.
Product Registration Visit tripplite.com/warranty today to register your new Tripp Lite product. You’ll be automatically entered into a drawing for a chance to win a FREE Tripp Lite product!* *No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.