No-Picture Problem - Eizo FlexScan SX3031W-H Setup Manual

Prior to use

No-Picture Problem

If no picture is displayed on the monitor even after the following remedial action is taken, contact your local dealer.
1. Check the Power indicator.
Symptom
No picture
2. Check the error message that remains on the screen.
These messages appear when the input signal is incorrect even if the monitor is functioning.
Symptom*
* When the display is set to dual display mode,
6
Installation Setting/Adjustment
Status
Power indicator does not light
up.
Power indicator lights blue.
Power indicator lights orange.
Status
The input signal is not received.
The signal frequency is outside
the specification. Incorrect
signal frequency is shown in
red.
or appears on the error message display to show the error display.
Troubleshooting
Possible cause and remedy
• Check whether the power cord is correctly
connected.
• Press .
Switch the input signal with
Press a key on the keyboard or click the mouse.
Turn on the PC.
Possible cause and remedy
Check whether the PC is turned on.
Check whether the signal cable is properly
connected to the PC.
Switch the input signal with
Change the mode to an appropriate mode using
the graphics board's utility software. Refer to the
manual of the graphics board for details.
.
.