Chapter 3 No-Picture Problem - Eizo RadiForce MX191 Instructions For Use Manual

Chapter 3 No-Picture Problem

If a problem still remains after applying the suggested remedies, contact your local EIZO representative.
Problem
1. No picture
• Power indicator does not light.
• Power indicator lights blue.
• Power indicator is lighting orange.
2. The message below appears.
• This message appears when no signal is
input.
Example:
• The message shows that the input signal is
out of the specified frequency range. (Such
frequency is displayed in yellow.)
Example:
fD: Dot clock (Displayed only during digital
signal input)
fH: Horizontal scan frequency
fV: Vertical scan frequency
16
Chapter 3 No-Picture Problem
Possible cause and remedy
• Check whether the power cord is connected properly.
• Press .
• Increase "Brightness", "Contrast" and "Gain" in the
adjustment menu. For more information, refer to the
Installation Manual (on the CD-ROM).
• Switch the input signal with
• Move the mouse or press any key on the keyboard.
• Check whether the PC is turned on.
This message appears when the signal is not input correctly
even when the monitor functions properly.
• The message shown left may appear, because some PCs
do not output the signal soon after power-on.
• Check whether the PC is turned on.
• Check whether the signal cable is connected properly.
• Switch the input signal with
• Check whether the PC is configured to meet the resolution
and vertical scan frequency requirements of the monitor
(see "2-1. Compatible Resolutions" (page 13)).
• Reboot the PC.
• Select an appropriate setting using the graphics board's
utility. Refer to the manual of the graphics board for
details.
.
.