Dual XDVDN8190 Installation & Owner's Manual page 89

Problem
Please connect There is no mobile device connected to the
first appears in the head unit
display
Mobile device will Bluetooth function is not active on the head unit
not connect to the
Bluetooth function is not active on the mobile
head unit
device
A mobile device is already connected to the head
unit This head unit can only be connected to one
device at a time
ERROR! Connect
The time limit for the pairing mobile device has
Timeout appears in been reached
the display
Pairing Fail appears The attempted pairing process has failed
in the display
Mobile device The Connect function is set to Manual. When
will not connect
the Connect function is set to Manual, the
to the head unit head unit will not connect to any mobile device
automatically automatically
Ring tone can not Ring tone volume is turned down
be heard through
the speakers
MUTE function is activated on the head unit
Echo or noise is
Possible road noise or interior interference
heard during a
Microphone opening on the front panel is
phone call
obstructed
Call is connected Audio is routed to the mobile device
(but no audio can
be heard through
Bluetooth audio is heard through the front
the speakers)
channel speaker outputs or the front preamp
outputs only
Bluetooth mode includes memory volume.
If Bluetooth volume is set to 0 when a call comes
in, no audio will be heard
Call is answered Auto Answer function is set to On
automatically
Caller ID does not The calling mobile device is not set to send the
appear during
Caller ID or, the service is not available
incoming call
XDVDN8190 does Cell phone ringer is set to off
not ring when
receiving a call
Bluetooth
Cause
XDVDN8190 OPERATION
Troubleshooting
Pair and or connect a mobile device to the head unit as
described on page 75
Activate Bluetooth function as described on page
Refer to the owner's manual of your mobile device
Disconnect current mobile device first, then connect desired
mobile device
Pair the mobile device within 120 seconds
Retry the pairing process again
Set Connect function to Auto as described on page
Increase the volume of the ring tone using the rotary encoder
during the ringing process
Press MUTE to cancel the mute function and resume audio
Close all open windows and turn off any fans or A/C
Clear any obstacles in front of microphone opening
Press Audio Transfer to allow audio from the phone to be
heard through the speakers
Adjust fader forward so there is audio to the front speakers. If
amplifiers are used only, be sure to use front preamp outputs
Adjust Bluetooth volume level above 0
Set Auto Answer function to Off as described on page
Some devices may not communicate or work properly with
this head unit
Set cell phone ringer to "on"
Action
19
74
74
88