Dual XDVDN9131 Installation & Owner's Manual page 12

Dvd multimedia receiver with gps navigation and 7” touch screen display
Hide thumbs Also See for XDVDN9131:
Table of Contents

Advertisement

XDVDN9131
Control Functions - Monitor Closed
End Button
Infrared Sensor
Reset
Front Panel
Removal/Attachment
Disc-in Indicator
11
OPERATION
Mode
Press MODE to select between Tuner, Disc (which includes DVD and CD
playback), operation of iPod, USB, Bluetooth, SD, Auxiliary 1 and Auxiliary 2
inputs. Each time the MODE button is pressed the next mode is chosen. Modes
of operation are indicated on the OSD or the secondary LCD. Optional iPod
device, USB flash drive, SD card or Bluetooth device must be
connected/inserted to appear in the mode selection string.
Press to end a call in progress or reject an incoming call.
Mute
Press MUTE to silence audio output. "Mute" will flash in the display. Press
MUTE again to restore audio at previous volume level. Press and hold MUTE to
toggle the Loudness function On or Off.
Point the remote control towards the infrared sensor to control various
functions of the unit. Refer to page 13 for more information.
Caution
Upon installation, do not attempt to move the monitor by hand. Use the
or
The unit will stop if it encounters any obstacles during the open/close
sequence. If this occurs, remove the obstacle and press OPEN again to
resume the monitor open/close sequence.
Press REL to fold down the front panel. In the down position, gently press the
right side of the front panel to the left, then pull away from the bottom right to
remove. To re-install the front panel, insert the right side of the bottom of the
front panel first, then snap the left side into place and fold up. It is easiest to
reattach the front panel whe it is in the open position.
Reset
To resolve abnormal operation or if the unit is inoperable, press the
RESET button located behind the front panel directly under the disc slot.
unit will reset the main processor to the default settings.
Note: Use the tip of a pen to access the reset button. To restore the factory
default software settings, refer to page
The disc-in indicator will illuminate blue when a disc is loaded.
buttons, the OPEN button on the front panel or the remote control.
19.
Disc-in
Indicator
The

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents