Using Locks - Dish Network Solo 111 User Manual

Chapter 3
Using the System
Page 36
10. If your VCR did not complete the test, enter another code from the
table, and then repeat steps 5 through 8.
11. Once you have found the correct VCR code select the
save the VCR code you entered and return to the
Setup menu.
Note : If the receiver can't control the VCR, use an Auto-Tune Event
Timer to tune the receiver to the channel you want to record. Use the
timers built into the VCR to start and stop the VCR at the right times.
L , B -O
OCKS LACKED UT
You must enter the receiver password before you can create an automatic
event timer for a locked program, and you must order a pay per view
program before you can create a timer for it. You can create a manual event
timer for a locked program without entering the password. However, if you
do this, or if the program is blacked out in your area, when the event timer
operates the receiver may display only an error or password entry menu. If
you have set a VCR Event Timer, the VCR will record only that menu.
P O E
OWER FF AND VENT
If the receiver is OFF at the time an Auto-Tune or VCR Event Timer is
scheduled to operate, the receiver will turn ON. Once the event has ended,
the receiver will turn OFF, unless you pressed any remote control or
receiver front panel buttons during the time that the timer was active.
If the receiver is OFF at the time a Reminder Event Timer is scheduled to
operate, the timer will turn the receiver ON and tune it to the channel you
last watched. The receiver will then display the reminder menu. You will
have a few seconds to respond. If you do not respond to the reminder menu,
the receiver will turn OFF.
U L
SING OCKS
First you set the locks; then you lock the receiver. You must
lock the receiver in order to put any locks into effect. If you
unlock the receiver, leave the locks unchanged, and then
lock the receiver again, the same locks will be in effect as
before.
H S L : A T
OW TO ET OCKS
1. Create the locks that you want.
2. Lock the receiver.
Once the receiver is locked, anyone who wants to access locked items
must enter the password.
P , E
ROGRAMS AND VENT
T
IMERS
S P
WO TEP ROCESS
option to
Save
Installation and
T
IMERS