Table of Contents
Advertisement
4. INSTALLATION GUIDE
The system must be installed by an authorized personnel from AOS Bath as the system can only be activated with
unique activation codes from the manufacturer.
Note: The hot water tank is specifically designed to be an under-sink tank and may not be installed on the
countertop or mounted on a wall. The recommended height distance between the tank and faucet is 60-80cm.
Failure to comply with proper installation requirements may result in a malfunction.
PREPARATION BEFORE INSTALLATION
1. Set aside a location for the hot water tank and faucet dispenser. The dispenser should be mounted on the
countertop and the tank should be below it, under the sink.
2. Check that you have the necessary tools on hand for the installation: An electric drill, a pair of needle-nosed
pliers, a countertop drill, a 3mm drill bit, an adjustable wrench (>37.5m opening), a cross screwdriver and a
slotted screwdriver.
INSTALLING THE FAUCET
If countertop surface is very thin, it follows that the faucet may be slightly unstable after installation. This is still
acceptable for operation.
Hot water
button
Spout
O-ring
Data cable
Hot water pipe
Lock bolt, flat
Base reinforcement
Room temp. water button
Touch screen display
Aerator
Body
Base cap
Nut
Exhaust
Room temp. water pipe
Mounting base
Lock bolt, base
1. Drilling
Drill a hole of 26-32mm in
diameter to begin the
installation.
Advertisement
Table of Contents
