Table of Contents
Advertisement
Problem solving guide
Problem
will flash alternately
with , or in
the timer display.
A message not listed in
this table is appearing
in the timer display.
Unexpected behaviour
Problem
The power level
selected is flashing.
The sensor controls
show increased
sensitivity or fail to
react.
Power level 9 is
automatically reduced if
you also set power
level 9 for the
connected cooking
zone.
48
Possible cause and remedy
The fan is blocked or defective.
Make sure the fan has not been blocked by an
object.
Remove the obstruction.
If this fault code continues to appear in the
display, contact Miele.
There is an electronic unit fault.
Interrupt the power supply to the SmartLine
appliance for approx. 1 minute.
If the problem persists after power is restored,
please contact Miele.
Possible cause and remedy
There is no pan on the cooking zone, or the pan is
unsuitable.
Use suitable pans (see "Induction - Cookware").
The sensitivity level of the sensor controls has
changed.
Make sure that there is no direct light (from the sun
or from an artificial source) falling onto the
SmartLine appliance. Also ensure the area
surrounding the SmartLine appliance is not too
dark.
Take any pans off the SmartLine appliance and
wipe away any food deposits.
Ensure that there is nothing covering the entire
SmartLine appliance or sensor controls.
Interrupt the power supply to the SmartLine
appliance for approx. 1 minute.
If the problem persists after power is restored,
please contact Miele.
Operating both zones at power level 9 exceeds the
permitted maximum power for the two zones.
Use a different cooking zone.
Advertisement
Table of Contents
