4-2. Recording performance
Mode: REC Monitor
INPUT SELECT: Un Bal [ unless otherwise spesified 特に指示のある場合を除く ]
Input terminal: ANALOG INPUT (UNBALANCED) [ unless otherwise spesified 特に指示のある場合を除く ]
Measurement point: ANALOG OUTPUT (UNBALANCED) [ unless otherwise spesified 特に指示のある場合を除く ]
INPUT SIGNAL
ITEM
項 目
1.
ANALOG INPUT
Record level
録音レベル
(BALANCED):
(BALANCE)
1 kHz, +20 dBu
2.
1 kHz, +6 dBV
Record level
録音レベル
(UNBALANCE)
3.
1 kHz, +6 dBV
Total harmonic
distortion
総合歪率
4.
20 Hz-20 kHz,
Overall frequency
+6 dBV
responce
録再周波数特性
5.
Overall SN ratio
録再SN比
6.
Lch: 1 kHz, +6 dBV
Channel separation
チャンネル
Rch: No signal
セパレーション
7.
1 kHz, +6 dBV
PHONES output
level
PHONES出力
レベル
録音系
入力信号
Rotate the INPUT (L, R) controls to positions at which the
"OVER" segments of the level meter is just about to light.
AT this tine, the output level should be +20 dBu ±2 dB.
INPUT (L,R)つまみを回して、レベルメータの OVER が
点灯する直前になるようにセットする。
このとき、出力は +20 dBu ± 2 dBであること。
Rotate the INPUT (L, R) controls to positions at which the
"OVER" segments of the level meter is just about to light.
AT this tine, the output level should be +6 dBV ±2 dB.
INPUT (L,R)つまみを回して、レベルメータの OVER が
点灯する直前になるようにセットする。
このとき、出力は +6 dBV ± 2 dBであること。
0.01 % or less
0 ± 1 dB
88 dB min.
Ratio between the L CH and R CH outputs: 75 dB min.
Also check the channel separation of L CH from R CH.
Lchの出力とRchの出力の比: 75 dB 以上
Rch→Lchも同様に確認すること。
Phones output level when the PHONE level control is set to
the maximum position: 1.1 V or more.
PHONESレベルつまみを最大にしたときのPHONES出力:
1.1 V 以上
SPECIFICATIONS
規 格
−7−
REMARKS
備 考
INPUT SELECT: Balance
Output terminal:
ANALOG OUTPUT
(BALANCED)
Do not vary the INPUT
control positions after the
adjustment. (These are
their specified positions.)
調整後、INPUTつまみは動
かさないこと。 (規定位置)
22 kHz LPF in
400 Hz HPF in
Reference level: 1 kHz
22 kHz LPF in
IEC-A
22 kHz LPF in
IEC-A
32Ω load