HP StorageWorks All-in-One SB600c Storage Blade Solution User Manual page 24

CAUTION:
To prevent possible server malfunction and damage to the equipment, multiprocessor configurations must
contain processors with the same part number.
CAUTION:
To prevent possible server blade overheating, always populate processor socket 2 with a processor and a
heatsink or a processor cover and a heatsink blank.
CAUTION:
The heatsink thermal interface media is not reusable and must be replaced if the heatsink is removed
from the processor after it has been installed.
IMPORTANT:
When installing the heatsink, align the guide pins on the processor retention bracket with the alignment
holes in the heatsink.
IMPORTANT:
Processor socket 1 must always be populated. If processor socket 1 is empty, the server blade does not
power up.
NOTE:
Do not discard the processor protective cover. Always install the processor protective cover if the
processor is removed from the socket.
To install the component:
1.
Power down the server blade.
See Powering down the HP All-in-One SB600c Storage Blade Solution
information.
2. Remove the server blade.
See Removing the HP AiO SB600c Server Blade
3. Remove the access panel.
See Removing the access panel
4. Remove all hard drives.
5. Remove the hard drive backplane.
24
Hardware Options installation and cabling
on page 20 for more information.
on page 21 for more information.
on page 19 for more