Inlet Hose Connection - Daewoo DWC-LD141X Instruction Manual

Inlet hose connection

The washer should be connected to the water mains using new hose sets and old hose sets should not be
reused.
In using only one water tap or in case of only one water inlet valve, connect the inlet hose to the cold water
inlet valve.
Option : Be careful not to confuse hot water inlet and cold water inlet.
For Ordinary Tap
Pull down the collar of the inlet
hose to separate it from the
water tap adapter.
Remove the tape, and screw
Raccorclement A
connector B into connect A
Raccorclement A
Raccorclement A
Raccorclement B
tightly. Raccorclement B
Raccorclement B
Raccorclement A
Raccorclement A
Raccorclement A
Raccorclement B
Raccorclement B
Raccorclement B
Raccorclement A
Raccorclement A
Raccorclement B
Raccorclement B
For Screw-Shaped Tap
Connect the inlet hose to the
water tap by screwing the
connector tightly.
Rubber
Connector
Packing Rubber
Rubber
Connector
Connector
Packing
Packing
Hose Rubber
Connector
Connector
Hose Connector Packing
Hose
Connector
Connector
Rubber
Rubber
Connector
Connector
Packing
Packing
Hose
Hose
Connector
E-6
Hose Rubber
Hose Rubber
Connector
Connector Connector
Connector
Packing
Packing
Hose
Hose
Connector
Connector
Loosen the four screws properly
in order to fit into water tap.
Connect the inlet hose to the
water tap adapter by pulling
down the collar of the hose end.
Raccorclement A
Raccorclement B
Connect the connector- inlet
supplied if necessary.
Connector
Connector
Connector
inlet
inlet
inlet
Rubber
Connector
Packing
Connector
Connector
Connector
Connector
inlet
Connector
Connector
inlet
Hose
Rubber Connector
Hose inlet
inlet
Hose
Connector
Packing
Connector
Connector
Connector
Connector
Connector
Connector
Connector
Hose
Connector Hose
inlet
inlet
Hose
Hose
Connector
Connector Connector
Hose Hose
Connector Connector
Fit the water tap adapter into
the water tap and tighten the
four screws evenly while
pushing up the adapter so that
the rubber packing can stick to
the water tap tightly.
Connect the inlet hose adapter
of the hose to the water inlet of
the washer by turning it
clockwise to be fixed tightly.
• Please check the rubber packing
present inside the inlet hose
adapter of the hose.
Connect the inlet hose adapter
to the water inlet of a washer
and turn it to be fixed.
Rubber
Rubber
Packing
Packing
Rubber
Rubber
Packing
Packing
Rubber
Rubber
*Check the packing in the inlet
Packing
Packing
Connector
Connector
Connector
Rubber
Rubber
Packing
Packing
TAPE
TAPE
TAPE
TAPE
TAPE
TAPE
TAPE
TAPE
TAPE