Connect; Place The Unit; Connect Speakers; Connect Video Cables - Philips FWD410 User Manual

3 Connect

Place the unit

1
Place the unit near the TV.

3ODFH WKH OHIW DQG ULJKW VSHDNHUV DW HTXDO
distance from the TV and at an angle
of approximately 45 degrees from the
listening position.
Note
‡
To avoid magnetic interference or unwanted noise,
never place both the main set and speakers too close
to any radiation devices.
‡
Place this unit on top of a table.
‡
Never place this unit in an enclosed cabinet.
‡
Place this unit near the AC outlet where the AC power
plug can be easily reached.
&RQQHFW VSHDNHUV
Note
‡
For better sound effect, use the supplied speakers only.
‡
Connect only speakers with impedance that is the
same or higher than the supplied speakers. Refer to the
VSHFLÀFDWLRQV VHFWLRQ RI WKLV PDQXDO
1
2Q WKH EDFN RI WKH PDLQ VHW ÀQG WKH OHIW
and right speaker sockets.

Check that the colors and polarities of the
speaker cables match those of the speaker
sockets.
3
Insert the speaker wires into the
corresponding speaker sockets.
a b
&RQQHFW YLGHR FDEOHV
Select the best video connection that the TV
can support.
‡ 2SWLRQ  Connect to the component
video sockets (for a standard TV or
Progressive Scan TV).
‡ 2SWLRQ  Connect to the video (CVBS)
socket (for a standard TV).
HIGH
HIGH
LOW
c
EN 11