π
Howard leigHt
earplug fitting guide
note: read and follow all earplug fitting
instructions prior to usage.
SElEctIOn
Avoid overprotection in minimal noise environments. In
selecting the best earplug for your situation, consider
noise levels and your need to communicate with
co-workers or to hear warning signals on the job.
1.
Reach over your head with
a free hand, pull ear up and
back, and insert earplug well
inside ear canal. (See Figure 1)
Figure 1
1.
With clean hands, roll the entire
earplug into the narrowest
possible cylinder. (See Figure 4)
Figure 4
PAGE 1 OF 2
®
1-800-295-5510
uline.com
general information
MAIntEnAncE
• Prior to wearing, inspect earplugs for dirt, damage
• For proper hygiene, discard single-use earplugs
• With proper maintenance, mutiple-use earplugs can
• clean and replace pods on banded earplugs
no-roll foam
2. Earplugs should be inserted as
shown in Figure 2. Stop pushing
earplug when your finger
touches your ear. (See Figure 2)
Figure 2
roll-down foam
2. Reach over your head with
a free hand, pull ear up and
back, and insert earplug well
inside ear canal. (See Figure 5)
Figure 5
or hardness. Discard immediately if compromised.
after use.
last for 2-4 weeks. clean with mild soap and water
and store in a case when not in use.
regularly.
3. If properly fitted, the end of the
earplugs should not be visible
to someone looking at you from
the front. (See Figure 3)
Figure 3
3. Hold for 30 to 40 seconds, until
the earplug fully expands in
your ear canal. If properly fitted,
the end of the earplugs should
not be visible to someone
looking at you from the front.
(See Figure 6)
Figure 6
0814 IS-7902