3.4.10 Removing the power transformer
(See Figs.14 and 15)
• Prior to performing the following procedures, remove the am-
plifier assembly and rear panel.
(1) From the top side of the amplifier assembly, disconnect the
wires from the connectors
er board. (See fig.14)
(2) Remove the four screws P attaching the power transform-
er, and take out the power transformer from the amplifier
assembly. (See fig.15)
Reference:
• When attaching the power transformer, attach the screws P
with the barrier. (See fig.15)
• After connect the wires from the connectors
CN151, bundle the wire by the wire clamp. (See Fig.14)
• When changing the new power transformer, renew the new
spacer (See fig.15)
1-34 (No.MB362)
CN102
and
CN151
on the moth-
CN102
Amplifier assembly
and
CN102
P
Barrier
Wire clamp
Mother board
CN151
Fig.14
Spacer
Power transformer
Fig.15
P