PREPARATION IMPORTANT! ■ Wear full eye and hearing protection while operating the It is essential that you read the instructions in this manual product. If working in an area where there is a risk of before assembling, operating, and maintaining the falling objects, head protection must be worn.
■ Beware, the cutting elements continue to rotate after the TRANSPORTATION AND STORAGE motor is turned off. ■ Turn off the product, remove the battery pack, and allow ■ Beware of objects thrown by the cutting means. Clear both to cool down before storing or transporting. debris like small stones, gravel, and other foreign objects ■...
SYMBOLS ON THE PRODUCT SYMBOLS IN THIS MANUAL Read and understand all the instructions Parts or accessories sold separately before operating the product. Follow all the warnings and safety instructions. Note Wear eye protection. Warning Wear ear protection. Wear non-slip safety footwear when using the product.
Page 6
Always wear safety goggles or safety Install the safety guard to the trimmer Turn the wing nut counter clockwise to glasses with side shields when head. Secure the safety guard into release the screw and the clamp from operating the product. Wear non-slip, place with screws.
Page 7
Operating the Operating the p.10 edger trimmer Cleaning the Replacing the p.11 p.12 Storing the product p.13 product spool...
OPERATING THE TRIMMER WARNING: Always use two hands to operate the product. Hold the product with the right hand on the rear handle and the left hand on the front handle. WARNING: Beware of objects thrown by the cutting means. Remove debris like small stones, gravel, and other foreign objects from the work area before starting operation.
Page 9
2. Hold the lock-out trigger, and squeeze the variable speed trigger to operate the product. Use the speed selector to adjust the speed from low to high. NOTE: Holding and releasing both the lock- out trigger and the variable speed trigger automatically releases a quarter inch of line.
OPERATING THE EDGER 1. Remove the battery pack. 2. Push the edging button. Rotate the lower shaft counterclockwise 180° to the edger 180° position 3. Insert the battery pack until the battery latch button clicks into place. 4. Hold the lock-out trigger, and squeeze the variable speed trigger to operate the product.
REPLACING THE SPOOL 1. Remove the battery pack. 2. Push the slider on the side of the spool retainer, and remove the spool cover. 3. Remove the spool. 4. Thread the line of the new spool through the eyelet. Install the new spool with the line and slot aligned with the eyelet in the string head.
CLEANING THE PRODUCT 1. Remove the battery pack. 2. Remove all foreign material from the product with a soft, dry brush. WARNING: Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use.
STORING THE PRODUCT WARNING: Ensure that the product is clean before storing. 1. Remove the battery pack. 2. Store the product vertically in a cool, dry, and well-ventilated place that is inaccessible to children and away from sources of ignition. Do not store the product outdoors.
PRODUCT SPECIFICATIONS REPLACEMENT PART Cordless line trimmer Complete spool RAC1211, RAC1204 R18XLTR24 / Model R18XLTR20 WARNING! The declared vibration total values and the Weight 2.5 kg declared noise emission values given in this instruction Voltage 18 V d.c. manual have been measured in accordance with a...