Table of Contents
Advertisement
English
31.4
Chain lubrication
Fully automatic, speed-controlled oil pump with
reciprocating piston - additional manual oil flow
control
Oil tank capacity:
31.5
Weight
Dry, without cutting attachment
MS 780:
MS 780
with wrap around handle‐
bar:
MS 780
with ripping handle:
31.6
Cutting attachment
The actual cutting length can be less than the
specified cutting length.
31.6.1
Rollomatic guide bars
Cutting lengths
53, 63, 75, 90, 105 cm
(pitch .404")
Groove width:
1.6 mm
31.6.2
Duromatic guide bars
Bar lengths
53, 63, 75, 80, 90, 97, 105,
120 cm
Groove width:
1.6 mm
31.6.3
Saw chains .404"
Rapid Micro (46 RM) Type 3668
Rapid Super (46 RS) Type 3946
Pitch:
Drive link gauge:
31.6.4
Chain sprockets
7-tooth for .404" (rim sprocket)
7-tooth for .404" (spur chain sprocket)
31.7
Exhaust Emissions
The CO
value measured in the EU type approval
2
procedure is specified at www.stihl.com/co2.
The measured CO
value was determined on a
2
representative engine in accordance with a
standardized test procedure under laboratory
conditions and does not represent either an
explicit or implied guarantee of the performance
of a specific engine.
The applicable exhaust emission requirements
are fulfilled by the intended usage and mainte‐
nance described in this instruction manual. The
type approval expires if the engine is modified in
any way.
32 Ordering Spare Parts
Please enter your saw model, serial number as
well as the part numbers of the guide bar and
40
3
700 cm
(0.7 l)
9.80 kg
9.95 kg
9.90 kg
.404" (10.26 mm)
1.6 mm
saw chain in the spaces provided. This will make
re-ordering simpler.
The guide bar and saw chain are subject to nor‐
mal wear and tear. When purchasing these
parts, always quote the saw model, the part
numbers and names of the parts.
Model
Serial number
Guide bar part number
Chain part number
33 Maintenance and Repairs
Users of this machine may only carry out the
maintenance and service work described in this
user manual. All other repairs must be carried
out by a servicing dealer.
STIHL recommends that you have servicing and
repair work carried out exclusively by an author‐
ized STIHL servicing dealer. STIHL dealers are
regularly given the opportunity to attend training
courses and are supplied with the necessary
technical information.
When repairing the machine, only use replace‐
ment parts which have been approved by STIHL
for this power tool or are technically identical.
Only use high-quality replacement parts in order
to avoid the risk of accidents and damage to the
machine.
STIHL recommends the use of original STIHL
replacement parts.
Original STIHL parts can be identified by the
STIHL part number, the { logo and the
STIHL parts symbol K (the symbol may appear
alone on small parts).
34 Disposal
Observe all country-specific waste disposal rules
and regulations.
32 Ordering Spare Parts
0458-550-0121-B
Advertisement
Table of Contents
