Windshield Wipers & Washers; Lifting Wipers / Wiper Service Mode - Kia stinger 2022 Features & Functions Manual

Hide thumbs Also See for stinger 2022:
Table of Contents

Advertisement

STEERING WHEEL CONTROLS
Windshield Wipers & Washers
To operate:
• Move lever up/down to change wiper modes
– MIST: Single wipe
– OFF: Wiper off
– AUTO: Auto Rain Sensing
– LO: Slow wipe
– HI: Fast wipe
• Pull to spray and wipe
Auto Rain Sensing
The rain sensor located on the upper end of the windshield glass is
designed to sense the amount of rainfall and control the wiping cycle for
the proper interval . The more it rains, the faster the wiper operates . When
the rain stops, the wiper stops .
To turn ON the auto rain sensing wipers, move lever up/down to AUTO .
To adjust the auto rain sensing wiper speed setting, move the speed control
switch
A
up/down .
QUICK TIPS
• When the Engine Start/Stop button is in the ON position and the wiper switch is in
AUTO mode, the wiper will automatically operate once to perform a self-check of
the system
• Set the wiper to the OFF position when the wiper is not in use
• If going through a car wash, remind the attendant to keep the vehicle in Neutral (N)
and keep the engine running . Also, disable the Smart Power Liftgate* lid control,
turn off the auto rain sensing wipers and fold in the mirrors
• Moving lever to HI increases Intermittent wipe frequency and wipe speed . Moving
lever to LO decreases frequency of wipes
A
• Pressing button
up increases Intermittent wipe frequency and wipe speed .
Pressing button down decreases frequency of wipes
Lifting Wipers (Wiper Service Mode)
To lift the windshield wipers to clean windshield, inspect or replace wiper
blades or raise wipers in snow/ice conditions without damaging the hood,
the blades need to be moved to the service position
With the ignition ON, turn the ignition OFF, and within 20 seconds
move the wiper switch to the MIST position
more than two seconds until the wiper blade is in the fully up position .
To return wipers to normal position, turn the ignition ON, then activate MIST .
ALWAYS CHECK THE OWNER'S MANUAL FOR COMPLETE
OPERATING INFORMATION AND SAFETY WARNINGS .
B
A
C
.
B
and hold the switch for
QR CODES
Wipers and Wiper
Stalk Video
Wiper Service Mode
Video
Refer to the inside front cover for
more information on QR codes .
www . y outube .com/KiaFeatureVideos
C
See section 4 in the Owner's
Manual for more information .
*IF EQUIPPED
31

Advertisement

Table of Contents
loading

Table of Contents