Table of Contents
Advertisement
STEERING WHEEL CONTROLS
A
Windshield Wipers & Washers
To operate:
§
Move lever up/down to change wiper modes
MIST: Single wipe
OFF: Wiper off
AUTO: Auto Rain Sensing
Pull to spray and wipe
§
Auto Rain Sensing*
The rain sensor located on the upper end of the windshield
glass senses the amount of rainfall and controls the wiping
cycle for the proper interval. The more it rains, the faster the
wiper operates. When the rain stops, the wiper stops.
To turn ON the auto rain sensing wipers, move lever up/
down to AUTO.
To adjust the auto rain sensing wiper speed setting, move
the speed control switch
Turn Signals & Fog Lights
To operate:
Move lever up/down for right/left turn signal
§
Slightly move lever up/down to activate one-touch lane
§
change signal
§
Press toggle switch
ALWAYS CHECK THE OWNER'S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS.
LO: Slow wipe
HI: Fast wipe
A
up/down.
A
up to turn fog lights ON/OFF
MIST: Single wipe
OFF: Wiper off
AUTO: Auto Rain Sensing
LO: Slow wipe
HI: Fast wipe
Quick Tips
- When the Engine Start/Stop button is in the ON
position and the wiper switch is in AUTO mode,
the wiper will automatically operate once to
perform a self-check of the system
- Set the wiper to the OFF position when the wiper
is not in use
- If going through a car wash, remind the
attendant to keep the vehicle in Neutral (N) and
keep the engine running. Also, disable the Smart
Power Liftgate* lid control, turn off the auto
rain sensing wipers and fold in the mirrors
REMINDERS:
- Headlights must be ON for fog light operation
- One-touch lane change signal is activated by
moving the turn signal lever slightly for less than
1 second and then releasing. The lane change
signal will blink 3 times
- To change how many times the lane change
signal blinks (3/5/7), go to User Settings in the
LCD instrument cluster modes
For more information on the User Settings Mode,
please refer to your Owner's Manual.
21
*IF EQUIPPED
Advertisement
Table of Contents
