General Operation - Coby CX CX-CD400 Operation Manual

GENERAL OPERATION

POWER SOURCES
Before connecting the Unit to an AC outlet, check that the operating voltage of the Unit
is identical with the voltage of your local power supply. Connect the supplied AC power
cord to the AC in jack.
BATTERY OPERATION
Switch the AC/DC selector to DC position. Open the Battery Compartment Door and
insert 8 UM-1 D size batteries, making sure that the indicated battery polarity is
observed.
Note: The AC cord must be completely disconnected if no AC/DC selector switch.
RADIO OPERATION
Slide the Function Switch to the RADIO position. Slide the Band Switch, as you prefer.
Turn the tuning knob to your desired radio station. Adjust the Volume Controls.
SPEAKER PLACEMENT
This unit features a detachable speaker system. The left and right speaker enclosures
can be detached from the main unit, and placed where desired. When the speakers
enclosure are attached to the main unit, the unit can be carried to any location desired.
TO ATTACH THE SPEAKER ENCLOSURES
1. Attach the speaker enclosure to the main unit about halfway up, and slide the
speaker enclosure to the locked position.
2. Extend the speaker wire to the desired length.
3. Insert the speaker wire plug into the SPEAKER JACK.
TO DETACH THE SPEAKER ENCLOSURE
1. Remove the speaker wire plug from the SPEAKER JACK.
2. Push the RELEASE lever as illustrated and lift the speaker enclosure.
3. Wind the excess speaker wire onto the post, on the back of each speaker enclosure.
FM STEREO INDICATOR
Slide Band Switch to FM position, The FM Stereo indicator is on if stereo broadcasts
are received.
ANTENNAS
Fully extend the Telescope Antenna to receive FM and SW (Option) stations. For AM
reception the unit has a built-in antenna. Turn the whole unit for best reception.