Valet Mode - Clifford 10.5X Owner's Manual

➜

valet mode

You can prevent your security system from automatically arming
and triggering by using Valet Mode. This is very useful when
washing the vehicle or having it serviced. In Valet Mode, the
security system will not arm, even with the remote transmitter,
but all convenience functions (door locks, trunk release, etc.)
will continue to work normally.
To enter or exit Valet Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.
The remote will respond with 5-flashes of the
beeps on entering or exiting Valet
To enter or exit Valet Mode using the transmitter:
1. Open any vehicle door.
Quickly press the following buttons in the sequence indicated.
2. Press .
3. Press .
4. Press again.
The in-vehicle status LED will light solidly if you are entering
Valet Mode, and it will go out if you are exiting Valet
®
© 2005 directed electronics, inc.
button within 10 seconds.
® Mode.
DRW-35
icon and 2
Mode.
®
31