Out Of Range; No Remote Output; Car Select - Clifford 330.3X Owner's Manual

Out of Range

Each time a command is performed the remote will expect a com-
mand confirmation from the system. If a command confirmation is not
received the out-of-range icon (
alert.

No Remote Output

Occasionally when a command is performed the remote may not
generate a command confirmation output or out of range output. This
indicates that the system received the command but it was an incom-
plete command (e.g. aux button pressed too short to activate the trunk
release) or it was an illegal message (e.g. the command was cor-
rupted due to local RF interference). These are temporary normal func-
tions of the system and remote, perform the command again within 10
seconds to return to normal operation.

Car Select

Car 2 must first be turned on (See Responder LC Configuration and
Main Menu sections to turn on).
Two Way Remote
Press and hold the
1.
beeps. The
is displayed.
CAR 2
2. Change car: While in this mode press the
between cars and the
indicating which car the remote currently operates.
3. Select the car you want to operate and then press any com-
mand to operate the system. The selected car remains selected
until the setting is changed.
© 2009 Directed Electronics. All rights reserved.
) and a fault tone will play as an
button for 3 seconds or until the remote
or icon flashes and the text
or
button to switch
icon changes accordingly
or
CAR 1
33